GOLDEN
- Waistband cut in 100% cotton drill
- Pocket cut in 100% cotton drill
- Type A reflective tape
- Domestic nylon zipper
- Domestic metal snaps
Back to Uniforms 
Hover over the photo to zoom in
Hover over the photo to zoom inTechnical data sheet
Industrial coverall · PDVSA 2021 standard · General use
WORKWEAR Cotton and blends for general industrial work. These are not flame-resistant fabrics.
Fabric color
Request a quote The photos show the cut of the garment. The fabric is chosen from the table below: the same cut is made up in any of them.
On-screen colors are for reference only and may vary with the fabric batch.
Download data sheet Manufacturer PDF, with construction detail and the fabric tableConstruction
Construction detail as declared on the manufacturer’s technical data sheet.
- Long or short sleeve
- Six pockets, laid out as follows:
- Two chest pockets with flaps
- Two front trouser pockets
- Two rear patch pockets, no flap
- Two-tone design
- Mandarin collar
- Front zipper concealed under a flap for extra protection
- Silver-grey reflective tape, 1”, single on sleeves, legs, waist and shoulders
- Elastic adjustment at the rear of the waist
- Cuffs with snap adjustment
- Embroidered with two patch-type logos (left chest and left sleeve)
- Sewn with 3-ply thread for stronger seams
- Double stitching with bar tacks at the highest-stress areas
Finish levels
The same garment with different hardware and waistband/pocket fabrics. The level is chosen when quoting.
BRONCE
- Waistband cut in Norwegian/Borneo drill
- Pocket cut in sabana versátil fabric
- Type B reflective tape
- Domestic metal zipper
- Domestic snaps
Available fabrics
Values declared by the manufacturer on the garment’s technical data sheet.
| Line | Fabric | Weight | Composition |
|---|---|---|---|
| Armura Basic | Drill 100% Algodón | 260 G/M2 · 7,67 OZ/Y2 | 100% cotton |
| Armura Basic | Drill Borneo | 235 G/M2 · 7 OZ/Y2 | 65% polyester · 35% cotton |
| Armura Basic | Drill Noruego | 190 G/M2 · 5,60 OZ/Y2 | 80% polyester · 20% cotton |