Industrial personal protection coverall · General use

WORKWEAR Cotton and blends for general industrial work. These are not flame-resistant fabrics.

Standard PDVSA EM-36-01/04 · Revision 9, March 2023

Fabric color

Request a quote

The photos show the cut of the garment. The fabric is chosen from the table below: the same cut is made up in any of them.

On-screen colors are for reference only and may vary with the fabric batch.

Construction

Construction detail as declared on the manufacturer’s technical data sheet.

Long or short sleeve

Six pockets, laid out as follows:

Two chest pockets with flap and snap

Two front trouser pockets, no false pocket

Two rear trouser pockets

Rear pockets are reinforced

One-piece back with piping

Elastic all around the waist

Sleeve cuff with placket

Triangle detail at the cuff

Full sport collar

Front nylon zipper, double slider

Grey reflective tape, 2.50 cm, single on sleeves, legs, waist and shoulders

Colour identification band on the shoulders (where applicable)

Metal snaps on pockets, collar and cuffs

Sewn with 3-ply thread for stronger seams

Double stitching with bar tacks at the highest-stress areas

Embroidered with two patch-type logos (left chest and left sleeve)

Finish levels

The same garment with different hardware and waistband/pocket fabrics. The level is chosen when quoting.

Available fabrics

Values declared by the manufacturer on the garment’s technical data sheet.

Fabric	Weight	Composition	Shrinkage %
DRIL 100% ALGODÓN	250 G/M2 · 7,5 OZ	100% cotton	3.0 warp · 3.0 weft
DRIL BORNEO	235-240 G/M2 · 7,5 OZ	65% polyester · 35% cotton	3-4%
DRIL NORUEGO	190 G/M2 · 7,5 OZ	80% polyester · 20% cotton	3-4%