Premium Drill Supervisor Coverall

WORKWEAR Cotton and blends for general industrial work. These are not flame-resistant fabrics.

Fabric color

Request a quote

The photos show the cut of the garment. The fabric is chosen from the table below: the same cut is made up in any of them.

On-screen colors are for reference only and may vary with the fabric batch.

Construction

Construction detail as declared on the manufacturer’s technical data sheet.

Long or short sleeve

Six pockets, laid out as follows:

Two diagonal chest pockets with zipper and flap

Two front trouser pockets

Two rear trouser pockets, one with zipper and flap

One vernier pocket on the left leg

One pen pocket on the left sleeve

Rear pockets are reinforced

Split back with piping

Elastic at both sides of the waist

Shirt-style cuff with hem

Sleeve tab with snap

Piping on the trouser front

Radio holder on the right chest

Sport collar

Front nylon zipper, double slider

Reflective tape, 1” or 2”, on arms and legs

Metal / plastic snaps on collar and cuffs

Sewn with 3-ply thread for stronger seams

Double stitching with bar tacks at the highest-stress areas

Embroidery to order, direct or patch type

Finish levels

The same garment with different hardware and waistband/pocket fabrics. The level is chosen when quoting.

Available fabrics

Values declared by the manufacturer on the garment’s technical data sheet.

Fabric	Weight	Composition	Shrinkage %
DRIL 100% ALGODÓN	250 G/M2 · 7,5 OZ	100% cotton	3.0 warp · 3.0 weft
DRIL BORNEO	235-240 G/M2 · 7,5 OZ	65% polyester · 35% cotton	3-4%
DRIL NORUEGO	190 G/M2 · 7,5 OZ	80% polyester · 20% cotton	3-4%